1, the water bath thermostat oscillator heating is normal, the oscillation speed becomes slower.
Solution: Open the side panel of the control cabinet, turn on the power, set the temperature control to 0 degrees (that is, no heating state), turn on the oscillation switch, adjust the speed to the highest, and find the two adjustable resistances on the speed control board. Adjust the right side counterclockwise to solve.
2, the water bath thermostat oscillator does not heat, oscillation is normal.
Solution: First determine whether the heating pipe is damaged. If it is damaged, it needs to be replaced. Then it is judged whether the temperature control part is damaged, and if it is damaged, it needs to be replaced.
3, water bath thermostat oscillator heating normal, oscillation can not work.
Solution: Open the side panel of the control cabinet, turn on the power, set the temperature control to 0 degrees (that is, no heating state), turn on the oscillation switch, adjust the speed to the highest, and use the multimeter to exchange 250 files to measure whether the transformer has 220V voltage input If it is not, then the switch is broken. Conversely, if there is no 12V voltage output (with AC 50V), then the transformer is bad if it is not available. Do not replace the transformer easily. In this case, there is usually a short circuit fault in the rectified part of the circuit board or the motor. (In this case, the appearance of the transformer is charred.) To eliminate the above situation, replace it. 12V voltage is normal, check whether there is DC 12 voltage (DC 50V file), if not, the rectifier bridge is disconnected and replaced. If yes, check whether the voltage is output to the motor (5-8V or so). If the motor is bad, or if the instrument is not used for a long time, the mechanical part will rust. If it is not, the high power tube in the control board will be damaged. The above method can basically solve the problem of no oscillation.
LYC-B Three Stage Oil Purifier
LYC-B Three Stage Oil Purifier is a type of moveble oil filter machine. It has one coarse filter and two fine filters. The filtration precision can up to 1 micron according to the different needs of the user. The flowrate are from 25l/min to 150l/min.
APPLICATION of LYC-B Three Stage Oil Purifier
â—Filter when the hydraulic lubrication system oiling
â—The bypass filter when the hydraulic lubrication system is working
â—The cycle filter before the hydraulic lubrication system put into operation
â—The oil of the hydraulic lubrication system doesn't filter pump-out by the pump of
the device itself.
Mobile Oil Purifier,High Precision Oil Purifier,Three Stage Oil Purifier Machine,Movable Oil Purifier
Xinxiang Tianrui Hydraulic Equipment CO.,LTD , https://www.filterelement.pl