Centrifugal pump water or difficult to start when troubleshooting

Centrifugal pump water or difficult to start troubleshooting is as follows:
【cause of issue】
(1) water pump irrigation dissatisfaction with water;
(2) pump irrigation can not enter the water;
(3) the valve leakage at the end of the valve closed;
(4) bottom valve stuck by debris;
(5) pump or suction pipe leak, vacuum pump pumping can not be a vacuum;
(6) vacuum system failure;
(7) vacuum pump insufficient supply of water or lack of suction capacity of the vacuum pump;
Exclusion
(1) Check the end of the valve and the suction pipe is leaking, the bottom of the pump emptying screw or valve is closed;
(2) Pump casing top or vent valve is open;
(3) a large number of irrigation, forcing the end of the valve closed, if not the end of the valve may have been bad. Must try to overhaul;
(4) Check the valve and try to remove debris;
(5) Check the suction pipe and connecting flange itself is leaking, tighten the packing gland. Check? 饫 淙? 玫 玫 玫 玫 玫 玫 玫 玫 玫 撞 撞 撞 撞 撞 撞 簟 簟 ???? ???? ???? ???? ???? ???? ???? ???? ???? 欠 欠 停 停 停 停 停 owed ┢ ┢ 穸 穸 due ow (6) check whether all valves in the exact position, whether the vacuum check valve failure;
(7) increase the vacuum pump make-up water, but the influent is too large or too high pressure will affect the vacuum efficiency. If there is no problem with the water, check? Suchan felt hat old owe 裢 旰 旰 旰? ⑾ Governance 侍 饧 蘩 蘩 恚

Galvanized Welded Mesh

Galvanized Welded Mesh,Hot Dipped Galvanized Wire Mesh,Galvanized Iron Wire Mesh,Galvanized Welded Wire Mesh

HEBEI ANPING YONG SHENG WIRE AND NETTING MAKING CO.,LTD , https://www.yshmesh.com

This entry was posted in on