The installation of the swing gate is critical, and the installation quality will directly affect the performance. Many customers do not understand the installation and do not pay attention to the installation. Some customers simply do not read the manual and do not understand the telephone manufacturers. Therefore, they must first read the pendulum carefully. The brake operator manual is very important. It is proficient in basic operation skills and will deepen influence in the actual operation process. It must be operated by professionals, otherwise it will damage the machine and cause unnecessary trouble. It is necessary to discuss with the new and old customers about the installation steps of the swing gate.
A, gate positioning:
According to the original design plan, determine the location of the gate to be installed, and the direction.
The ground is flat. If the slope surface must be flat, it is best to communicate with Party A to confirm the location.
Second, slotting:
Do not open the line to open the slot, the dark line is to be slotted at the bottom, take the two 6 points PVC pipe, one go strong, one go weak, strong power 220 volts, 1.5-2 points, weak walk 4 core shielded cable, Network cable use.
Third, the swing gate fixed:
Fixed gate position, 4-M10*100 expansion screws, horizontal symmetry. Before and after the symmetry, uniform, the front chassis and the back of the swing bar gap 50-80mm as well, too small will hit the chassis, too easy to excel.
Fourth, install the pendulum:
Power is on, and the swing shaft is in the middle of the swing shaft, and the swing rod is installed and fastened. A lot of customers took a swing bar, which is very easy to install. Once installed, it will cause the pendulum to hit the chassis.
Fifth, access control registration:
Some customers have already registered at the factory. They can use the card directly (no registration is required). If the card is registered, it must be connected to the access control board with a network cable and connected to the computer. The card issuance machine can even issue a card on the card issuing machine to manage the card. Software, then register and register for operation, the card number corresponds to the cardholder's name, credit card records only generate the card number, through the card number to find the relevant cardholders and access to the information.
Six, maintenance:
Safely keep the software and register information. In case of poor communication or faulty gates, refer to the instructions, be sure to maintain and maintain by professional personnel. Record, maintain, and use conditions of the gates regularly, clean the access data, and copy them to a computer for backup. Change oil once a month or so, the appearance of clean, plug the circuit.
Life Fitness Accessories,Wholesale Fitness Accessories,Fitness Equipment Accessories,Gym Accessories For Men
Foshan Laijian Fitness Equipment Co., Ltd. , https://www.gymljfitness.com